Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › TRANSAXLE REAR COVER

TRANSAXLE REAR COVER > DISASSEMBLY

for Preparation Click here



1. REMOVE TRANSAXLE REAR COVER PLUG


C067881
  1. Remove the 4 transaxle rear cover plugs from the transaxle rear cover.

  1. Using a screwdriver, remove the 4 O-rings from the 4 transaxle rear cover plugs.



2. REMOVE OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


D008358
  1. Using SST, a press and a screwdriver, remove the snap ring.

    SST
    09387-00070  

    NOTICE:
    Stop pressing the press when the overdrive brake piston is lowered to 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, to prevent the overdrive brake piston from being deformed.

  1. Remove the overdrive brake return spring from the transaxle rear cover.



3. REMOVE 2ND COAST AND OVERDRIVE BRAKE PISTON


C067883
  1. Apply compressed air (392 kPa, 4.0 kgf/cm2, 57 psi) to the transaxle rear cover to remove the overdrive brake piston.

    NOTICE:
    1. Blowing the air may cause the piston to jump out. When removing the piston, hold it by hand using a shop rag or piece of cloth.
    2. Do not splash ATF with the compressed air.



4. REMOVE 2ND COAST AND OVERDRIVE O-RING


C067884
  1. Using a screwdriver, remove the 2 O-rings from the 2nd coast and overdrive brake piston.



5. REMOVE CLUTCH DRUM OIL SEAL RING


C067885
  1. Remove the 3 oil seals from the transaxle rear cover.



6. REMOVE TRANSAXLE REAR COVER NEEDLE ROLLER BEARING


C082194E01
  1. Using SST, remove the bearing from the transaxle rear cover.

    SST
    09387-00041   (09387-01021)