Home › TRANSMISSION ยท U340E AUTOMATIC TRANSAXLE › TRANSAXLE REAR COVER

TRANSAXLE REAR COVER > REASSEMBLY

for Preparation Click here



1. INSTALL TRANSAXLE REAR COVER NEEDLE ROLLER BEARING


C067888E01
  1. Coat a new needle roller bearing with Toyota Genuine ATF WS.

  1. Using SST and a press, install the needle roller bearing into the transaxle rear cover.

    SST
    09950-60010   (09951-00190, 09952-06010)
    09950-70010   (09951-07100)

    Standard clearance:
    25.2 mm (0.992 in.)



2. INSTALL CLUTCH DRUM OIL SEAL RING


D025116E01
  1. Compress the oil seal ring from both sides to reduce dimension A.

    Dimension A:
    5.0 mm (0.197 in.)

  1. Coat the oil seal ring with Toyota Genuine ATF WS and install it onto the transaxle rear cover.



3. INSTALL 2ND COAST AND OVERDRIVE O-RING


C067884
  1. Coat 2 new O-rings with Toyota Genuine ATF WS and install them into the 2nd coast and overdrive brake piston.

    NOTICE:
    Do not damage the O-rings.



4. INSTALL 2ND COAST AND OVERDRIVE BRAKE PISTON


C067889
  1. Coat the piston with Toyota Genuine ATF WS and install it into the transaxle rear cover.

    NOTICE:
    Do not damage the O-rings.



5. INSTALL OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY


D008358
  1. Using SST and a press, install the overdrive brake return spring and snap ring onto the transaxle rear cover.

    SST
    09387-00070  

    NOTICE:
    1. Stop pressing the press when the spring seat is lowered to 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, to prevent the spring seat from deforming.
    2. Do not expand the snap ring excessively.



6. INSTALL TRANSAXLE REAR COVER PLUG


C067881
  1. Coat 4 new O-rings with Toyota Genuine ATF WS, and install them into the 4 transaxle rear cover plugs.

  1. Install the 4 transaxle rear cover plugs into the transaxle rear cover.

    Torque:
    7.4 N*m{ 75 kgf*cm , 65 in.*lbf }

    NOTICE:
    Do not damage the O-rings.