OUTPUT SHAFT > INSPECTION |
| 1. INSPECT OUTPUT SHAFT |
![]() |
Using a dial gauge and 2 V-blocks, check the output shaft runout.
![]() |
Using a micrometer, measure the outer diameter of the output shaft journal surface, at the locations indicated.
| 2. INSPECT 2ND GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 2nd gear.
| 3. INSPECT 1ST GEAR |
![]() |
Using a cylinder gauge, measure the inside diameter of the 1st gear.
| 4. INSPECT 1ST GEAR THRUST WASHER |
![]() |
Using a micrometer, measure the 1st gear thrust washer.
| 5. INSPECT SYNCHRONIZER RING NO.1 (FOR 2ND GEAR) |
![]() |
Check for wear and damage.
Coat the 2nd gear cone with gear oil.
Turn the synchronizer ring in one direction while pushing it against the 2nd gear cone.
Check that the ring locks.
If the synchronizer ring does not lock, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring back and the gear spline end.
| 6. INSPECT SYNCHRONIZER RING NO.1 (FOR 1ST GEAR) |
![]() |
Check for wear and damage.
Coat the 1st gear cone with gear oil.
Turn the synchronizer ring in one direction while pushing it against the 1st gear cone.
Check that the ring locks.
If the synchronizer ring does not lock, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring back and the gear spline end.
| 7. INSPECT REVERSE GEAR |
![]() |
Using a vernier calipers, measure the width of the reverse gear groove (A) and the thickness of the claw part on the reverse shift fork (B), and calculate the clearance.
| 8. INSPECT TRANSMISSION CLUTCH HUB NO.1 |
![]() |
Check that transmission clutch hub No. 1 and the reverse gear slide smoothly.
Check that the edges of the reverse gear spline gear are not worn down.