INPUT SHAFT > DISASSEMBLY |
| 1. INSPECT 4TH GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the 4th gear thrust clearance.
| 2. INSPECT 3RD GEAR THRUST CLEARANCE |
![]() |
Using a dial gauge, measure the 3rd gear thrust clearance.
| 3. INSPECT 4TH GEAR RADIAL CLEARANCE |
![]() |
Using a dial indicator, measure the 4th gear radial clearance between the gear and shaft.
| 4. INSPECT 3RD GEAR RADIAL CLEARANCE |
![]() |
Using a dial gauge, measure the 3rd gear radial clearance between the gear and shaft.
| 5. REMOVE 4TH GEAR |
![]() |
Using 2 screwdrivers and a hammer, remove the input shaft rear bearing shaft snap ring from the input shaft.
![]() |
Using SST and a press, remove the input shaft rear radial ball bearing and 4th gear from the input shaft.
| 6. REMOVE 4TH GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 4th gear needle roller bearing and 4th gear bearing spacer from the input shaft.
| 7. REMOVE 4TH GEAR SYNCHRONIZER RING |
![]() |
Remove synchronizer ring No. 2 from transmission clutch hub No. 2.
| 8. REMOVE 3RD GEAR |
![]() |
Using 2 screwdrivers and a hammer, remove the clutch hub No. 2 setting shaft snap ring from the input shaft.
![]() |
Using SST and a press, remove transmission clutch hub No. 2 and the 3rd gear from the input shaft.
| 9. REMOVE 3RD GEAR SYNCHRONIZER RING |
![]() |
Remove synchronizer ring No. 2 from the 3rd gear.
| 10. REMOVE 3RD GEAR NEEDLE ROLLER BEARING |
![]() |
Remove the 3rd gear needle roller bearing from the input shaft.
| 11. REMOVE TRANSMISSION HUB SLEEVE NO.2 |
![]() |
Remove transmission hub sleeve No. 2, the 3 shifting keys and 3 shifting key springs from transmission clutch hub No. 2.