INPUT SHAFT > REASSEMBLY |
| 1. INSTALL TRANSMISSION HUB SLEEVE NO.2 |
![]() |
Coat transmission hub sleeve No. 2 with gear oil, and install it to transmission clutch hub No. 2.
Using a screwdriver, install the 3 synchromesh key springs with 3 synchromesh shifting keys onto transmission clutch hub No. 2.
| 2. INSTALL 3RD GEAR NEEDLE ROLLER BEARING |
![]() |
Coat the 3rd gear needle roller bearing with gear oil and install it onto the input shaft.
| 3. INSTALL 3RD GEAR |
![]() |
Coat the 3rd gear with gear oil and install it onto the input shaft.
| 4. INSTALL 3RD GEAR SYNCHRONIZER RING |
![]() |
Coat the 3rd gear synchronizer ring with gear oil and install it onto the 3rd gear.
| 5. INSTALL TRANSMISSION CLUTCH HUB NO.2 |
![]() |
Using SST and a press, install transmission clutch hub No. 2 onto the input shaft.
![]() |
Select a snap ring that will allow minimum axial play.
| Mark | Thickness mm (in.) | Mark | Thickness mm (in.) |
| 0 | 2.30 (0.0906) | 3 | 2.48 (0.0976) |
| 1 | 2.36 (0.0929) | 4 | 2.54 (0.1000) |
| 2 | 2.42 (0.0953) | 5 | 2.60 (0.1024) |
Using a brass bar and a hammer, install the snap ring onto the input shaft.
| 6. INSTALL 4TH GEAR SYNCHRONIZER RING |
![]() |
Coat the 4th gear synchronizer ring with gear oil and install it onto transmission clutch hub No. 2.
| 7. INSTALL 4TH GEAR NEEDLE ROLLER BEARING |
![]() |
Coat the 4th gear needle roller bearing and 4th gear bearing spacer with gear oil and install them onto transmission clutch hub No. 2.
| 8. INSTALL 4TH GEAR |
![]() |
Coat the 4th gear with gear oil and install it onto the input shaft.
| 9. INSTALL INPUT SHAFT REAR RADIAL BALL BEARING |
![]() |
Using SST and a press, install the input shaft rear radial ball bearing onto the input shaft.
![]() |
Select a snap ring that will allow minimum axial play.
| Mark | Thickness mm (in.) | Mark | Thickness mm (in.) |
| A | 2.29 (0.0901) | D | 2.47 (0.0972) |
| B | 2.35 (0.0925) | E | 2.53 (0.0996) |
| C | 2.41 (0.0948) | F | 2.59 (0.1019) |
Using a brass bar and a hammer, install the snap ring onto the input shaft.
| 10. INSPECT 3RD GEAR RADIAL CLEARANCE |
![]() |
Using a dial gauge, measure the 3rd gear radial clearance.
| 11. INSPECT 4TH GEAR RADIAL CLEARANCE |
![]() |
Using a dial gauge, measure the 4th gear radial clearance.
| 12. INSPECT 3RD GEAR THRUST CLEARANCE |
![]() |
Using a dial gauge, measure the 3rd thrust clearance.
| 13. INSPECT 4TH GEAR THRUST CLEARANCE |
![]() |
Using a feeler gauge, measure the 4th thrust clearance.