MANUAL TRANSAXLE UNIT > INSPECTION |
| 1. INSPECT SYNCHRONIZER RING NO.3 |
![]() |
Check for wear and damage.
Coat the 5th gear cone with gear oil.
Turn the synchronizer ring in one direction while pushing it against the 5th gear cone.
Check that the ring locks.
If the synchronizer ring does not lock, replace the synchronizer ring.
![]() |
Using a feeler gauge, measure the clearance between the synchronizer ring back and the gear spline end.
| 2. INSPECT TRANSMISSION HUB SLEEVE NO.3 |
![]() |
Check the sliding condition between transmission hub sleeve No. 3 and transmission clutch hub No. 3.
Check that the edges of the transmission hub sleeve No. 3 spline gear are not worn down.
![]() |
Using vernier calipers, measure the width of the transmission hub sleeve No. 3 groove (A) and the thickness of the claw part on the gear shift fork No. 3 (B), and calculate the clearance.
| 3. INSPECT 5TH GEAR |
![]() |
Using a caliper gauge, measure the inside diameter of the 5th gear.
| 4. INSPECT REVERSE IDLER GEAR SUB-ASSEMBLY |
![]() |
Using a caliper gauge, inspect the reverse idle gear.
Using a micrometer, inspect the reverse idler gear shaft.