Home › BODY ELECTRICAL › AUDIO / VISUAL › PILLAR SPEAKER (for Hatchback)

PILLAR SPEAKER (for Hatchback) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT NO. 2 SPEAKER

HINT:
Remove interior parts so that the front No. 2 speaker can be seen.

  1. Check the speaker installation.

    OK:
    The speaker is securely installed.

    If the result is not as specified, reinstall the front No. 2 speaker.

  1. Visually check the speaker.

    OK:
    The cone paper of the speaker is not torn.

    If the result is not as specified, replace the front No. 2 speaker.



    E064124E01
  1. Check the speaker resistance.

    1. Disconnect the front No. 2 speaker connector.

    2. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1(TWR-) - 2(-)
      Below 1 Ω
      3(TWRH) - 4(+)
      Below 1 Ω

      If the result is not as specified, replace the front No. 2 speaker.