REAR CENTER SEAT OUTER BELT ASSEMBLY (for Hatchback 3 Door) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Luggage Compartment Room Light) |
| 2. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (w/ Package Tray Trim) |
![]() |
Remove the 2 package tray trim suspenders.
Remove the 5 pieces of hook tape.
Disengage the 2 claws and remove the package tray trim.
| 3. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board) |
![]() |
Release the 2 knobs and remove the deck board.
| 4. REMOVE SPARE WHEEL COVER ASSEMBLY (w/ Deck Board) |
![]() |
Remove the spare wheel cover.
| 5. REMOVE DECK FLOOR BOX RH (w/ Deck Board) |
![]() |
Release the 2 knobs and remove the deck floor box.
| 6. REMOVE DECK FLOOR BOX LH (w/ Deck Board) |
| 7. REMOVE REAR FLOOR CARPET ASSEMBLY (w/o Deck Board) |
![]() |
Remove the rear floor carpet.
| 8. REMOVE NO. 1 REAR SEAT LEG COVER |
for RH Side:
Remove the No. 1 rear seat leg cover .
for LH Side:
Remove the No. 1 rear seat leg cover .
| 9. REMOVE NO. 2 REAR SEAT LEG COVER |
![]() |
Disengage the 3 claws in the sequence shown in the illustration and remove the No. 1 rear seat leg cover.
| 10. REMOVE REAR SEAT ASSEMBLY RH |
![]() |
Using "TORX" socket wrench E10, remove the 2 bolts and pull up the rear seat cushion.
![]() |
Using "TORX" socket wrench E10, remove the 4 bolts and the rear seat.
| 11. REMOVE REAR SEAT ASSEMBLY LH |
![]() |
Using "TORX" socket wrench E10, remove the 3 bolts and pull up the rear seat cushion.
![]() |
Using "TORX" socket wrench E10, remove the 4 bolts and the rear seat.
| 12. REMOVE FRONT DOOR SCUFF PLATE RH |
![]() |
Disengage the 8 claws and remove the front door scuff plate.
| 13. REMOVE FRONT DOOR SCUFF PLATE LH |
| 14. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH |
![]() |
Remove the front door opening trim weatherstrip to the extent that the front quarter trim panel can be removed.
| 15. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH |
| 16. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY RH (w/ Seat Belt Bar) |
![]() |
Remove the 2 bolts and the front seat outer belt bar.
| 17. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY LH (w/ Seat Belt Bar) |
| 18. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH |
![]() |
Remove the belt of the rear seat outer belt from the rear seat shoulder belt hanger.
![]() |
Disengage the 8 clips, the retainer and the 10 claws and remove the front quarter trim panel.
| 19. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH |
| 20. REMOVE REAR DECK TRIM COVER |
![]() |
for Temper Spare Tire:
Using a clip remover, remove the 2 clips.
Disengage the 8 claws and remove the rear deck trim cover.
![]() |
for Grand Tire:
Using a clip remover, remove the 2 clips.
Disengage the 8 claws and remove the rear deck trim cover.
| 21. REMOVE REAR SEAT OUTER BELT ASSEMBLY RH |
![]() |
Remove the bolt.
Disengage the clip and remove the anchor plate.
| 22. REMOVE REAR SEAT OUTER BELT ASSEMBLY LH |
| 23. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH |
![]() |
Remove the 3 screws.
Disengage the 3 clips and the 3 claws and remove the deck side trim panel.
| 24. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH |
![]() |
w/ Luggage Compartment Room Light:
Remove the 3 screws.
Disengage the 3 clips and the 3 claws.
Disconnect the deck side room light connector and remove the deck side trim panel.
w/o Luggage Compartment Room Light:
Remove the 3 screws.
Disengage the 3 clips and the 3 claws and remove the deck side trim panel.
| 25. REMOVE ROOF SIDE INNER GARNISH RH |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the center belt guide.
![]() |
w/ Curtain shield Airbag:
Disengage the 4 clips and the claw.
Pass the rear seat outer belt and the rear center seat outer belt through the slit of the roof side inner garnish and remove the roof side inner garnish.
![]() |
w/o Curtain Shield Airbag:
Disengage the 4 clips and the claw.
Pass the rear seat outer belt and the rear center seat outer belt through the slit of the roof side inner garnish and remove the roof side inner garnish.
| 26. REMOVE ROOF SIDE INNER GARNISH LH |
![]() |
w/ Curtain Shield Airbag:
Disengage the 4 clips and claw.
Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.
![]() |
w/o Curtain Shield Airbag:
Disengage the 4 clips and claw.
Pass the rear seat outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.
| 27. REMOVE REAR CENTER SEAT OUTER BELT ASSEMBLY |
![]() |
Remove the 2 tongue plates.
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and open the slip joint cover.
![]() |
Remove the bolt and the through anchor.
![]() |
Remove the bolt, the hook and the bracket.
![]() |
Remove the bolt, the 2 hooks and the retractor.
| 28. REMOVE SEAT BELT ANCHOR COVER |
![]() |
Using a moulding remover, disengage the 4 claws and remove the seat belt anchor cover.
| 29. REMOVE ROOF HEADLINING ASSEMBLY |
![]() |
Using a clip remover, remove the clip and the roof headlining.
| 30. REMOVE REAR SEAT SHOULDER BELT COVER |
![]() |
Disengage the 2 claws and remove the rear seat shoulder belt cover.