Home › SUSPENSION & AXLE › SUSPENSION › REAR SHOCK ABSORBER (for Sedan)

REAR SHOCK ABSORBER (for Sedan) > REMOVAL

for Preparation Click here



1. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)


    B138595
  1. Hold the front edge of the rear seat cushion cover pad and lift it up, as shown in the illustration, to disengage the 2 hooks.

    NOTICE:
    Hold the area around the hooks so as to avoid deforming the rear seat cushion frame.

  1. Pass the rear seat inner belt through the slit in the rear seat cushion cover pad, disengage the hook between the rear seat cushion cover pad and the rear seatback, and remove the rear seat cushion cover pad.



2. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type)


    B138450E02
  1. Remove the rear seat outer belt from the rear seat shoulder belt guide.

    HINT:
    Use the same procedure for both sides.

  1. for 3 Point Type Rear Center Seat belt:

    1. Remove the rear center seat outer belt from the rear center seat shoulder belt guide.



    B134981
  1. Remove the 3 bolts.

  1. Disengage the 3 hooks and remove the rear seatback.



3. REMOVE REAR WHEEL


4. REMOVE REAR SHOCK ABSORBER CAP


5. REMOVE REAR SHOCK ABSORBER
  1. Support the axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.



    C132100
  1. Remove the 2 nuts while keeping the piston rod from rotating.

  1. Remove the cushion retainer and suspension support.



    C106031
  1. Remove the bolt while keeping the nut from rotating and remove the shock absorber.

    NOTICE:
    Remove the nut from the bolt side because the one on the lower side is a jam nut.



6. REMOVE REAR SUSPENSION SUPPORT STOPPER


7. REMOVE REAR SUSPENSION SUPPORT ASSEMBLY