Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

ELECTRONIC POWER STEERING SYSTEM > TS and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

The power steering ECU can be changed from normal mode to the mode for the torque sensor zero point calibration by turning the ignition switch to ON after the DLC3 TS and CG terminals have been connected.

WIRING DIAGRAM


C162283E04


INSPECTION PROCEDURE

1.INSPECT DLC3 TERMINAL VOLTAGE
H102392E97
  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D15-12 (TS) - D15-4 (CG)
    Ignition switch ON
    11 to 14 V



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE 

2.CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)
H102392E98
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D15-4 (CG) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - DLC3)


    C122912E04
  1. Disconnect the connector from the power steering ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D31-11 (TS) -D15-12 (TS)
    Always
    Below 1 Ω
    D31-11 (TS ) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU