Home › SUSPENSION & AXLE › SUSPENSION › REAR COIL SPRING (for Hatchback)

REAR COIL SPRING (for Hatchback) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE REAR WHEEL


3. DRAIN BRAKE FLUID

NOTICE:
Immediately wash off any brake fluid that comes into contact with any painted surfaces.



4. SEPARATE SKID CONTROL SENSOR WIRE (w/ ABS)


C125279
  1. Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.

    NOTICE:
    Do not remove the connector cover from the connector because the skid control sensor wire may be damaged.



    C107566
  1. Remove the nut and separate the skid control sensor wire.



5. SEPARATE REAR LH FLEXIBLE HOSE


C107567E02
  1. Using SST, separate the brake tube from the flexible hose.

    SST
    09023-00100  

  1. Remove the clip and disconnect the flexible hose from the axle beam.



6. SEPARATE REAR RH FLEXIBLE HOSE

HINT:
The removal procedure for the RH side is the same as that for the LH side.



7. LOOSEN REAR AXLE BEAM


C112605E05
  1. Loosen the 2 bolts.

    NOTICE:
    Do not remove the bolts.



8. REMOVE REAR ABSORBER CAP


9. REMOVE REAR ABSORBER CAP


10. REMOVE REAR SHOCK ABSORBER CAP LH


11. REMOVE REAR SHOCK ABSORBER CAP RH


12. REMOVE REAR SHOCK ABSORBER LH
  1. Support the axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.



    C106030
  1. Remove the 2 nuts while keeping the piston rod from rotating.

  1. Remove the cushion retainer and suspension support.



    C106031
  1. Remove the bolt while keeping the nut from rotating and remove the shock absorber.

    NOTICE:
    Remove the nut from the bolt side because the one on the lower side is a jam nut.



13. REMOVE REAR SHOCK ABSORBER RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



14. REMOVE REAR COIL SPRING LH
  1. Lower the jacks slowly.

  1. Remove the coil spring, coil spring insulator upper and coil spring insulator lower.



15. REMOVE REAR COIL SPRING RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.