Home › SUSPENSION & AXLE › SUSPENSION › REAR AXLE BEAM (for Hatchback)

REAR AXLE BEAM (for Hatchback) > REPLACEMENT

for Preparation Click here



1. REMOVE REAR AXLE CARRIER BUSH LH


C107558E02
  1. Place a matchmark on the axle beam with it aligned with the bush mark.

  1. Using a chisel and hammer, bend the 2 portions of the bush rib.

    NOTICE:
    Bend the bush rib until the claw of SST can be suspended.

  1. Using SST, remove the bush from the axle beam.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04020, 09955-04011, 09957-04010, 09958-04011)
    09612-30012  
    09950-60010   (09951-00590)

    NOTICE:
    Apply paint to any scratches on the rear axle beam.



2. REMOVE REAR AXLE CARRIER BUSH RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.



3. INSTALL REAR AXLE CARRIER BUSH LH


C107559E01
  1. Align the matchmarks on a new bush and the axle beam and provisionally install the bush onto the axle beam, as shown in the illustration.

    NOTICE:
    Install the new bush in the same orientation as the old one was prior to removal, because they are directional.



    C107560E02
  1. Using SST, install the bush onto the axle beam.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04030, 09955-04051, 09957-04010, 09958-04011)
    09950-60020   (09951-00810, 09387-02010)
    09223-15020  

    NOTICE:
    Do not damage the rubber portion when installing the bush.



4. INSTALL REAR AXLE CARRIER BUSH RH

HINT:
The installation procedure for the RH side is the same as that for the LH side.