REAR AXLE BEAM (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type) |
![]() |
Hold the front edge of the rear seat cushion cover pad and lift it up, as shown in the illustration, to disengage the 2 hooks.
Pass the rear seat inner belt through the slit in the rear seat cushion cover pad, disengage the hook between the rear seat cushion cover pad and the rear seatback, and remove the rear seat cushion cover pad.
| 3. REMOVE REAR SEATBACK ASSEMBLY (for Fixed Seat Type) |
![]() |
Remove the rear seat outer belt from the rear seat shoulder belt guide.
for 3 Point Type Rear Center Seat belt:
Remove the rear center seat outer belt from the rear center seat shoulder belt guide.
![]() |
Remove the 3 bolts.
Disengage the 3 hooks and remove the rear seatback.
| 4. REMOVE REAR WHEEL |
| 5. DRAIN BRAKE FLUID |
| 6. SEPARATE SKID CONTROL SENSOR WIRE (w/ ABS) |
![]() |
Using a screwdriver, remove the claw of the connector lock portion and disconnect the skid control sensor wire connector.
![]() |
Remove the nut and separate the skid control sensor wire.
| 7. SEPARATE REAR NO. 4 BRAKE TUBE |
![]() |
Using SST, separate the brake tube from the flexible hose.
Remove the clip and disconnect the flexible hose from the axle beam.
Remove the nut and separate the brake tube.
| 8. SEPARATE REAR NO. 3 BRAKE TUBE |
| 9. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Using pliers, pinch both ends of the claw of cable clamp and flex the clamp to remove it.
Remove the bolt and separate the parking brake cable.
Remove the cable clamp from the parking brake cable.
| 10. SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY |
| 11. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake and remove the rear brake drum.
If the rear brake drum cannot be removed easily, perform the following procedure.
![]() |
Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
| 12. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH |
![]() |
Remove the 4 bolts and remove the axle hub and bearing from the axle beam.
| 13. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY RH |
| 14. LOOSEN REAR AXLE BEAM |
![]() |
Loosen the 2 bolts.
| 15. REMOVE REAR SHOCK ABSORBER CAP LH |
| 16. REMOVE REAR SHOCK ABSORBER CAP RH |
| 17. REMOVE REAR SHOCK ABSORBER LH |
Support the axle beam with a jack. Insert a wooden block between the jack and the rear axle spring seat to prevent damage.
![]() |
Remove the 2 nuts while keeping the piston rod from rotating.
Remove the cushion retainer and suspension support.
![]() |
Remove the bolt while keeping the nut from rotating and remove the shock absorber.
| 18. REMOVE REAR SHOCK ABSORBER RH |
| 19. REMOVE REAR COIL SPRING LH |
Lower the jacks slowly.
Remove the coil spring, coil spring insulator upper and coil spring insulator lower.
| 20. REMOVE REAR COIL SPRING RH |
| 21. REMOVE REAR AXLE BEAM |
![]() |
Remove the 2 bolts and remove the axle beam.