CLUTCH PEDAL (for Sedan LHD) > INSTALLATION |
| 1. INSTALL CLUTCH PEDAL NO.1 CUSHION |
![]() |
Install the clutch pedal No. 1 cushion onto the clutch pedal.
| 2. INSTALL CLUTCH PEDAL BUSH |
![]() |
Apply MP grease to the 2 bushes and collar.
Install the 2 bushes and collar onto the clutch pedal.
| 3. INSTALL CLUTCH PEDAL PAD |
| 4. INSTALL CLUTCH PEDAL SUB-ASSEMBLY |
![]() |
Install the clutch pedal onto the clutch pedal support with the bolt and the nut.
| 5. INSTALL CLUTCH PEDAL SPRING |
| 6. INSTALL CLUTCH PEDAL STOPPER BOLT |
![]() |
Install the clutch pedal stopper bolt so that its end touches the clutch pedal cushion.
| 7. INSTALL CLUTCH START SWITCH ASSEMBLY |
![]() |
Install the clutch start switch with the nut.
| 8. INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY |
![]() |
Install the clutch pedal support onto the vehicle with the bolt.
Connect the clutch start switch connector.
Connect the wire harness clamp.
| 9. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY |
![]() |
Install the clutch master cylinder with the 2 nuts.
| 10. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench 10 mm, connect the flexible hose tube.
| 11. INSTALL CLUTCH RESERVOIR TUBE |
Connect the clutch reservoir tube with the clip to the clutch master cylinder assembly.
| 12. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY UPPER |
| 13. INSTALL BRAKE BOOSTER ASSEMBLY |
| 14. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY |
Pull back the floor carpet.
![]() |
Check that the pedal height is correct.
If the pedal height is not as specified, adjust it as follows.
Loosen the lock nut and turn the stopper bolt until the correct height is obtained.
Tighten the lock nut.
| 15. INSPECT CLUTCH START SWITCH ASSEMBLY |
![]() |
Check the resistance between the terminals when the switch is ON and OFF.
| Switch position | Specified Condition |
| ON (pushed in) | Below 1Ω |
| OFF (released) | 10 kΩ or higher |