Home › TRANSMISSION ยท CLUTCH › CLUTCH MASTER CYLINDER (for Sedan LHD)

CLUTCH MASTER CYLINDER (for Sedan LHD) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS


C125987E01
  1. Install the lock nut onto the push rod.

  1. Install the push rod clevis.

  1. Tighten the lock nut and check the dimension A is same as the dimension A that has been measured.



2. INSTALL CLUTCH MASTER CYLINDER ASSEMBLY


C115307
  1. Install the clutch master cylinder with the 2 nuts.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



3. CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE


C115313
  1. Using a union nut wrench 10 mm, connect the flexible hose tube.

    Torque:
    without union nut wrench:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }
    with union nut wrench:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    NOTICE:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a fulcrum length of 22 mm (0.866 in.) (Click here).
    2. This torque value is effective when the union nut wrench is parallel to a torque wrench.



4. INSTALL CLUTCH RESERVOIR TUBE
  1. Connect the clutch reservoir tube with the clip to the clutch master cylinder assembly.



5. INSTALL BRAKE BOOSTER ASSEMBLY
(Click here)


6. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY
  1. Pull back the floor carpet.



    C115306E01
  1. Check that the pedal height is correct.

    Pedal height from floor:
    for 1NZ-FE:
    133.0 to 143.0 mm (5.236 to 5.630 in.)
    for 2NZ-FE:
    118.1 to 128.1 mm (4.650 to 5.043 in.)

  1. If the pedal height is not as specified, adjust it as follows.

    1. Loosen the lock nut and turn the stopper bolt until the correct height is obtained.

    2. Tighten the lock nut.

      Torque:
      16 N*m{ 160 kgf*cm , 12 ft.*lbf }