Home › TRANSMISSION ยท CLUTCH › CLUTCH RELEASE CYLINDER

CLUTCH RELEASE CYLINDER > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY


C115310
  1. Install the clutch release cylinder with the 2 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 8.7 ft.*lbf }



2. CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE


C106347
  1. Using a union nut wrench 10 mm, connect the flexible hose tube.

    Torque:
    without union nut wrench:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }
    with union nut wrench:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

    NOTICE:
    1. This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and a union nut wrench with a fulcrum length of 22 mm (0.866 in.) (Click here).
    2. This torque value is effective when the union nut wrench is parallel to a torque wrench.



3. BLEED CLUTCH PIPE LINE
  1. Fill the brake reservoir tank with brake fluid and bleed the clutch system.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



4. CHECK FOR CLUTCH FLUID LEAKAGE