Home › TRANSMISSION ยท C54 MANUAL TRANSAXLE › TRANSMISSION CONTROL CABLE (for Hatchback)

TRANSMISSION CONTROL CABLE (for Hatchback) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


3. REMOVE CONSOLE BOX ASSEMBLY REAR


B118993
  1. Remove bolt <F>.

  1. Disengage the 2 clips and remove the console box rear.



4. DISCONNECT OXYGEN SENSOR CONNECTOR (for Unleaded Gasoline Specification Vehicle)


5. REMOVE EXHAUST PIPE ASSEMBLY FRONT (for Unleaded Gasoline Specification Vehicle)
  1. Remove the 4 bolts and 4 compression springs.



  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


    A119126

  1. Remove the 2 exhaust pipe gaskets.



6. REMOVE EXHAUST PIPE ASSEMBLY FRONT (for Leaded Gasoline Specification Vehicle)
  1. Remove the 4 bolts and 4 compression springs.



  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


    A115389

  1. Remove the 2 exhaust pipe gaskets.



7. REMOVE FRONT FLOOR HEAT INSULATOR NO.1
  1. Remove the 2 bolts and nut and remove floor heat insulator No. 1.



8. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Disconnect the control shift cable from the shift lever.

  1. Turn the lock to release it and separate the control shift cable from the shift lever retainer.

  1. Remove the clip and disconnect the control select cable from the shift lever.

  1. Turn the lock to release it and separate the control select cable from the shift lever retainer.



    C115305
  1. Remove the 2 clips and the 2 washers, and disconnect the 2 cables from the transaxle.

  1. Remove the 2 clips and disconnect the 2 cables from the control cable bracket.



    C106362
  1. Remove the 3 nuts and remove the transmission control cable.