Home › TRANSMISSION ยท C54 MANUAL TRANSAXLE › TRANSMISSION CONTROL CABLE (for Sedan)

TRANSMISSION CONTROL CABLE (for Sedan) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY


    B132387
  1. Remove the shift lever knob.



4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



5. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the console upper rear panel.



6. REMOVE CONSOLE BOX CARPET


B132346
  1. Remove the console box carpet.



7. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



8. DISCONNECT OXYGEN SENSOR CONNECTOR (for Unleaded Gasoline Specification Vehicle)


9. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Unleaded Gasoline Specification Vehicle)
  1. Remove the 4 bolts and 4 compression springs.



  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


    A119126

  1. Remove the 2 exhaust pipe gaskets.



10. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for Leaded Gasoline Specification Vehicle)
  1. Remove the 4 bolts and 4 compression springs.



  1. Remove exhaust pipe support No. 4 and the exhaust front pipe assembly.


    A115389

  1. Remove the 2 exhaust pipe gaskets.



11. REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR
  1. Remove the 2 bolts and nut and remove floor heat insulator No. 1.



12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Disconnect the control shift cable from the shift lever.

  1. Turn the lock to release it and separate the control shift cable from the shift lever retainer.

  1. Remove the clip and disconnect the control select cable from the shift lever.

  1. Turn the lock to release it and separate the control select cable from the shift lever retainer.



    C115305
  1. Remove the 2 clips and the 2 washers, and disconnect the 2 cables from the transaxle.

  1. Remove the 2 clips and disconnect the 2 cables from the control cable bracket.



    C106362
  1. Remove the 3 nuts and remove the transmission control cable.