Home › BRAKE › BRAKE CONTROL › YAW RATE AND ACCELERATION SENSOR (for Hatchback)

YAW RATE AND ACCELERATION SENSOR (for Hatchback) > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE AND ACCELERATION SENSOR
  1. Connect the yaw rate and acceleration sensor connector.

  1. Install the yaw rate and acceleration sensor with the 2 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



2. INSTALL REAR CONSOLE BOX ASSEMBLY


C116873
  1. Engage the 2 clips and install the console box with the bolt.



3. INSTALL CONSOLE BOX CARPET


C109008
  1. Install the console box carpet.



4. INSTALL REAR CONSOLE BOX COVER


C109006E01
  1. Engage the 8 claws to install the console box rear cover.



5. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


C109005E01
  1. Engage the 6 claws to install the shifting hole cover.



6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


7. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
(Click here).


8. CHECK VSC SENSOR SIGNAL
(Click here).