Home › BRAKE › BRAKE CONTROL › YAW RATE AND ACCELERATION SENSOR (for Sedan)

YAW RATE AND ACCELERATION SENSOR (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL YAW RATE AND ACCELERATION SENSOR
  1. Connect the yaw rate and acceleration sensor connector.

  1. Install the yaw rate and acceleration sensor with the 2 bolts.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }



2. INSTALL REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.



3. INSTALL CONSOLE BOX CARPET


    B132346
  1. Install the console box carpet.



4. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY


    B132348
  1. Connect the connector.

  1. Engage the 3 clips and 3 claws and install the console upper rear panel.



5. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B132347
  1. Engage the 5 clips and the claw and install the upper console panel.



6. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY


7. INSTALL CENTER LOWER INSTRUMENT PANEL FINISH PANEL


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.



8. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
(Click here).


9. CHECK VSC SENSOR SIGNAL
(Click here).