Home › BRAKE › PARKING BRAKE › PARKING BRAKE CABLE (for Hatchback)

PARKING BRAKE CABLE (for Hatchback) > REMOVAL

for Preparation Click here



1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


2. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


C109005E01
  1. Disengage the 6 claws and remove the shifting hole cover.



3. REMOVE CONSOLE BOX COVER REAR


C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.



4. REMOVE CONSOLE BOX CARPET


C109008
  1. Remove the console box carpet.



5. REMOVE REAR CONSOLE BOX ASSEMBLY


C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.



6. REMOVE REAR WHEEL


7. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Release the parking brake and remove the rear brake drum.
    If the rear brake drum cannot be removed easily, perform the following procedure.



    F046068E02
  1. Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.

  1. Using another screwdriver, contract the brake shoe by turning the adjusting bolt.



8. REMOVE FRONT FLOOR NO. 4 HEAT INSULATOR


C108997
  1. Remove the 2 nuts and remove the heat insulator.



9. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY (for RH Side)


A118750E02
  1. Pinch and remove the clip as shown in the illustration.

  1. Remove the bolt and fuel tank cover vent case.



10. LOOSEN NO. 1 WIRE ADJUSTING NUT


C116905E01
  1. Loosen the lock nut and the adjusting nut.



11. REMOVE PARKING BRAKE CABLE
  1. Disconnect the cable end from the equalizer.



  1. Remove cable clamp A from the body.


    C162915E01

  1. Remove the 4 bolts.

  1. Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.



    C109000
  1. Remove the bolt and remove the parking brake cable from the backing plate.