PARKING BRAKE CABLE (for Sedan) > REMOVAL |
| 1. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.
| 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Remove the shift lever knob.
| 3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Shift the shift lever into the N position.
Disengage the 5 clips and the claw and remove the upper console panel.
| 4. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY |
![]() |
Disengage the 3 clips and 3 claws.
Disconnect the connector and remove the console upper rear panel.
| 5. REMOVE CONSOLE BOX CARPET |
![]() |
Remove the console box carpet.
| 6. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() |
Disconnect the clamp.
Remove the 2 bolts and 2 screws.
Disengage the 4 claws and remove the rear console box.
| 7. REMOVE REAR WHEEL |
| 8. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY |
Release the parking brake and remove the rear brake drum.
If the rear brake drum cannot be removed easily, perform the following procedure.
![]() |
Remove the hole plug and insert a screwdriver through the hole into the backing plate, and hold the automatic adjust lever away from the adjuster.
Using another screwdriver, contract the brake shoe by turning the adjusting bolt.
| 9. REMOVE REAR BRAKE SHOE KIT |
![]() |
Using SST, separate the shoe return spring from the front brake shoe.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and front brake shoe.
Remove the tension spring.
![]() |
Remove the shoe return spring from the rear brake shoe and remove the parking brake shoe strut set.
![]() |
Using SST, remove the shoe hold down spring cup, shoe hold down spring, pin and rear brake shoe.
![]() |
Using needle-nose pliers, separate the parking brake cable.
| 10. REMOVE FRONT FLOOR NO. 4 HEAT INSULATOR |
![]() |
Remove the 2 nuts and remove the heat insulator.
| 11. REMOVE FUEL TANK COVER VENT CASE SUB-ASSEMBLY (for RH Side) |
![]() |
Pinch and remove the clip as shown in the illustration.
Remove the bolt and fuel tank cover vent case.
| 12. LOOSEN NO. 1 WIRE ADJUSTING NUT |
![]() |
Loosen the lock nut and adjusting nut.
| 13. REMOVE PARKING BRAKE CABLE |
Disconnect the cable end from the equalizer.
Remove cable clamp A from the body.

Remove the 4 bolts.
Using pliers, pinch both ends of the claw of cable clamp B and flex the clamp to remove it.
![]() |
Remove the bolt and remove the parking brake cable from the backing plate.
Remove the cable clamp B from the parking brake cable.