Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER (for Hatchback)

PARKING BRAKE LEVER (for Hatchback) > INSTALLATION

for Preparation Click here



1. INSTALL PARKING BRAKE SWITCH


C109013
  1. Install the parking brake switch with the screw.

    Torque:
    0.9 N*m{ 9 kgf*cm , 8 in.*lbf }



2. INSTALL PARKING BRAKE LEVER


C109012
  1. Install the parking brake pull rod and parking brake equalizer, and then provisionally install the adjusting nut and the lock nut.



    C109011
  1. Install the parking brake lever with the 3 bolts.

    Torque:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }

  1. Connect the parking brake switch connector.



3. INSTALL PARKING BRAKE NO. 2 CABLE ASSEMBLY
  1. Connect the parking brake cable to the parking brake equalizer.



4. INSTALL PARKING BRAKE NO. 3 CABLE ASSEMBLY
  1. Connect the parking brake cable to the parking brake equalizer.



5. INSPECT PARKING BRAKE LEVER TRAVEL
  1. Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.

    Parking brake lever travel:
    6 to 9 clicks at 200 N (20 kgf, 45 lbf)



6. ADJUST PARKING BRAKE LEVER TRAVEL


C116905E01
  1. Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.

    Parking brake lever travel:
    6 to 9 clicks at 200 N (20 kgf 45 lbf)

  1. Tighten the lock nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.

  1. Check whether the parking brake drags or not.

  1. When operating the parking brake lever, check that the brake warning light illuminates.

    Standard:
    Brake warning light always illuminates at the first click.



7. INSTALL REAR CONSOLE BOX ASSEMBLY


C116873
  1. Engage the 2 clips and install the console box with the bolt.



8. INSTALL CONSOLE BOX CARPET


C109008
  1. Install the console box carpet.



9. INSTALL CONSOLE BOX COVER REAR


C109006E01
  1. Engage the 8 claws to install the console box rear cover.



10. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


C109005E01
  1. Engage the 6 claws to install the shifting hole cover.



11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }