PARKING BRAKE LEVER (for Sedan) > INSTALLATION |
| 1. INSTALL PARKING BRAKE SWITCH |
![]() |
Install the parking brake switch with the screw.
| 2. INSTALL PARKING BRAKE LEVER |
![]() |
Install the parking brake pull rod and parking brake equalizer, and then provisionally install the adjusting nut and the lock nut.
![]() |
Install the parking brake lever with the 3 bolts.
Connect the parking brake switch connector.
| 3. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY |
Connect the parking brake cable to the parking brake equalizer.
| 4. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY |
Connect the parking brake cable to the parking brake equalizer.
| 5. INSPECT PARKING BRAKE LEVER TRAVEL |
Slowly pull the parking brake lever to the fully applied position, counting the number of clicks.
| 6. ADJUST PARKING BRAKE LEVER TRAVEL |
![]() |
Loosen the lock nut and turn the adjusting nut until the parking brake lever travel is corrected to within the specified range.
Tighten the lock nut.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
Check whether the parking brake drags or not.
When operating the parking brake lever, check that the brake warning light illuminates.
| 7. INSTALL REAR CONSOLE BOX ASSEMBLY |
![]() |
Engage the 4 claws and install the rear console box.
Install the 2 bolts and 2 screws.
Connect the clamp.
| 8. INSTALL CONSOLE BOX CARPET |
![]() |
Install the console box carpet.
| 9. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY |
![]() |
Connect the connector.
Engage the 3 clips and 3 claws and install the console upper rear panel.
| 10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Engage the 5 clips and the claw and install the upper console panel.
| 11. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Install the shift lever knob.
| 12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |