Home › BRAKE › PARKING BRAKE › PARKING BRAKE SWITCH (for Sedan)

PARKING BRAKE SWITCH (for Sedan) > INSPECTION

for Preparation Click here



1. INSPECT PARKING BRAKE SWITCH
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:

      Tester Connection
      Switch Condition
      Specified Condition
      1 - Ground
      Released
      Below 1 Ω
      1 - Ground
      Pushed in
      10 kΩ or higher

      If the result is not as specified, replace the parking brake switch.