Home › ENGINE ยท 1NZ-FE › EMISSION CONTROL › EMISSION CONTROL SYSTEM

EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FUEL CUT-OFF RPM
  1. Start and warm up the engine.

  1. Increase the engine speed to approximately 3,500 rpm.

  1. Using a sound scope, check the operation sound of the injector.

  1. Release the throttle lever. Check that the operation noise stops momentarily and then resumes.



2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS


B000412E01
  1. Check that there are no cracks, leakage or scratches on the hoses, connections or gaskets.

    HINT:
    1. Removing the oil level gauge, oil filter cap or PCV hose may cause the engine to malfunction or stall.
    2. Disconnections, looseness or cracks in the parts of the air induction system between the intake system and cylinder head will allow air suction and cause the engine to run improperly.