Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1551/51    IG Power Supply Voltage Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU distinguishes the ignition switch status as on (IG) or off through the IG power source circuit.

DTC No.
DTC Detection Condition
Trouble Area
C1551/51
Open or short in IG power source circuit with ignition switch on (IG).
  1. ECU-IG fuse
  2. IG power source circuit
  3. Power steering ECU

WIRING DIAGRAM


C105152E07


INSPECTION PROCEDURE

1.READ VALUE USING DATA LIST (IG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item IG Power Supply in the Data List and read the value displayed on the intelligent tester.

    Standard Voltage:
    11 to 14 V



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.INSPECT FUSE (ECU-IG)


    C120678E06
  1. Remove the ECU-IG fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG fuse
    Always
    Below 1 Ω



NG
INSPECT SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)


    C162262E04
  1. Disconnect the connectors from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    D31-6 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER STEERING ECU