Home › STEERING › POWER STEERING › ELECTRONIC POWER STEERING SYSTEM

DTC    C1552/52    PIG Power Source Circuit

DTC    C1553/53    When Resetting Voltage, Vehicle is Being Driven

DTC    C1554/54    EPS Relay Circuit

DTC    C1555/55    EPS Motor Relay Circuit

for Preparation Click here


DESCRIPTION

When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because each relay is built into the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1552/52
PIG power source circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
C1553/53
Abnormal overvoltage
  1. IG and PIG power source circuit
  2. Power steering ECU
C1554/54
Power source relay circuit malfunction
  1. EPS fuse
  2. PIG power source circuit
  3. Power steering ECU
C1555/55
Motor relay circuit malfunction
  1. Power steering ECU
  2. Steering column assembly (Power steering motor)

WIRING DIAGRAM


C105153E07


INSPECTION PROCEDURE

1.READ VALUE USING DATA LIST (PIG POWER SUPPLY)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item PIG Power Supply in the Data List and read the value displayed on the intelligent tester.

    Standard voltage:
    Always 11 to 14 V



NG
Go to step 2
OK

CHECK INTERMITTENT PROBLEMS 

2.INSPECT FUSE (EPS FUSE)
C117909E03
  1. Remove the EPS fuse from the engine room relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    EPS fuse
    Always
    Below 1 Ω



NG
INSPECT SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


3.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU - BODY GROUND)


    C162260E05
  1. Disconnect the connector from the power steering ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    A19-1 (PIG) - Body ground
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A19-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT STEERING COLUMN ASSEMBLY (POWER STEERING MOTOR)


    C162261E05
  1. Disconnect the connector from the power steering ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    b1-11 (M) - b1-2 (M2)
    Always
    0.08 to 0.15 Ω
    b1-1 (M1) - Body ground
    Always
    1 M Ω or higher
    b1-2 (M2) - Body ground
    Always
    1 M Ω or higher



NG
REPLACE STEERING COLUMN ASSEMBLY
OK

REPLACE POWER STEERING ECU