HEATED OXYGEN SENSOR (for Sensor 2) > INSTALLATION |
| 1. INSTALL HEATED OXYGEN SENSOR |
![]() |
Using SST, install the sensor onto the front exhaust pipe.
Pass the sensor connector through the floor panel and install the grommet.
Connect the sensor connector.
| 2. INSTALL CONSOLE BOX ASSEMBLY REAR (for Hatchback) |
![]() |
Engage the 2 clips and install the console box with the bolt.
| 3. INSTALL INSTRUMENT PAD LOWER LH (for Sedan) |
Engage the claw and 3 clips and install the instrument pad lower.
Install screw <I>.
| 4. INSTALL REAR CONSOLE BOX ASSEMBLY (for Sedan) |
![]() |
Engage the 4 claws and install the rear console box.
Install the 2 bolts and 2 screws.
Connect the clamp.
| 5. INSTALL REAR CONSOLE BOX ASSEMBLY (for Hatchback) |
![]() |
Engage the 8 claws to install the console box rear cover.
| 6. INSTALL CONSOLE BOX CARPET (for Sedan) |
![]() |
Install the console box carpet.
| 7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan) |
![]() |
Connect the connector.
Engage the 3 clips and 3 claws and install the console upper rear panel.
| 8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan) |
![]() |
Engage the 5 clips and the claw and install the upper console panel.
| 9. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Engage the 6 claws to install the shifting hole cover.
| 10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) |
![]() |
Install the shift lever knob.
| 11. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for Sedan) |
![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.
| 12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan) |
![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.
| 13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 14. CHECK FOR EXHAUST GAS LEAKAGE |