Home › ENGINE ยท 2NZ-FE › EMISSION CONTROL › HEATED OXYGEN SENSOR (for Sensor 2)

HEATED OXYGEN SENSOR (for Sensor 2) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


A115424E01
  1. Using SST, install the sensor onto the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. Pass the sensor connector through the floor panel and install the grommet.

  1. Connect the sensor connector.



2. INSTALL CONSOLE BOX ASSEMBLY REAR (for Hatchback)


C116873
  1. Engage the 2 clips and install the console box with the bolt.



3. INSTALL INSTRUMENT PAD LOWER LH (for Sedan)
  1. Engage the claw and 3 clips and install the instrument pad lower.

  1. Install screw <I>.



4. INSTALL REAR CONSOLE BOX ASSEMBLY (for Sedan)


    B132349
  1. Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.



5. INSTALL CONSOLE BOX COVER REAR (for Hatchback)


C109006E01
  1. Engage the 8 claws to install the console box rear cover.



6. INSTALL CONSOLE BOX CARPET (for Sedan)


    B132346
  1. Install the console box carpet.



7. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan)


    B132348
  1. Connect the connector.

  1. Engage the 3 clips and 3 claws and install the console upper rear panel.



8. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan)


    B132347
  1. Engage the 5 clips and the claw and install the upper console panel.



9. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


C109005E01
  1. Engage the 6 claws to install the shifting hole cover.



10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    B132388
  1. Install the shift lever knob.



11. INSTALL INSTRUMENT PANEL FINISH PANEL END LH (for Sedan)


B132317
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.



12. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan)


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.



13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



14. CHECK FOR EXHAUST GAS LEAKAGE