Home › ENGINE ยท 2NZ-FE › EMISSION CONTROL › HEATED OXYGEN SENSOR (for Sensor 2)

HEATED OXYGEN SENSOR (for Sensor 2) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER (for Sedan)


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH (for Sedan)


B132317
  1. Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.



4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


    B132387
  1. Remove the shift lever knob.



5. REMOVE SHIFTING HOLE COVER SUB-ASSEMBLY (for Manual Transaxle)


C109005E01
  1. Disengage the 6 claws and remove the shifting hole cover.



6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (for Sedan)


    B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



7. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY (for Sedan)


    B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the console upper rear panel.



8. REMOVE CONSOLE BOX CARPET (for Sedan)


B132346
  1. Remove the console box carpet.



9. REMOVE CONSOLE BOX COVER REAR (for Hatchback)


C109006E01
  1. Disengage the 8 claws and remove the console box rear cover.



10. REMOVE CONSOLE BOX ASSEMBLY REAR (for Hatchback)


C116873
  1. Remove the bolt and disengage the 2 clips to remove the console box.



11. REMOVE REAR CONSOLE BOX ASSEMBLY (for Sedan)


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



12. REMOVE INSTRUMENT PAD LOWER LH (for Sedan)


B132339
  1. Remove screw <I>.

  1. Disengage the claw and 3 clips and remove the instrument panel pad lower.



13. REMOVE HEATED OXYGEN SENSOR
  1. Disconnect the sensor connector.

  1. Remove the grommet and pass the sensor connector out of the cabin through the floor panel.



    A115424E01
  1. Using SST, remove the heated oxygen No. 2 sensor.

    SST
    09224-00010