Home › ENGINE · 2NZ-FE › ENGINE CONTROL SYSTEM › INTEGRATION RELAY

INTEGRATION RELAY > INSPECTION

for Preparation Click here



1. INSPECT INTEGRATION NO.1 RELAY


A107023E04
  1. Inspect EFI (20A) fuse.

    1. Disconnect the fuse.

    2. Using an ohmmeter, measure the resistance of the fuse.

      Standard resistance:
      Tester Connection
      Specified condition
      1 - 2
      Below 1 Ω

  1. Inspect EFI relay.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:

      Tester Connection
      Specified condition
      A1 - C1
      Below 1 Ω
      A1 - A4
      10 kΩ or higher
      A4 - C1
      10 kΩ or higher
      A1 - A4
      Below 1 Ω
      (Apply battery voltage between terminals A2 and A3)
      A4 - C1
      Below 1 Ω
      (Apply battery voltage between terminals A2 and A3)

      NOTICE:
      While using the battery for the inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.