Home › ENGINE ยท 1NZ-FE › ENGINE CONTROL SYSTEM › INTEGRATION RELAY

INTEGRATION RELAY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE RELAY BLOCK COVER NO. 1


B108188E01
  1. Open the instrument panel box.

  1. Pull the hinge side of the instrument panel box out horizontally with the instrument panel open and disengage the 2 hinges.

  1. Remove the stopper of the instrument panel box from the cutout of the instrument panel lower and remove the instrument panel box.



3. REMOVE INTEGRATION NO.1 RELAY


A115400
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and disconnect the integration relay.

  1. Disconnect the 3 connectors.