Home › ENGINE ยท 1NZ-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL

ACCELERATOR PEDAL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ASSEMBLY


    A117072E02
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG) and turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / Data List / Accelerator Pedal Position No. 1 and Accelerator Pedal Position No. 2.

  1. While the accelerator pedal is depressed and released, check that the values of accelerator pedal position No. 1 and accelerator pedal position No. 2 are within the specification.

    Accelerator Pedal Position No. 1 Standard voltage:
    Condition
    Specified Condition
    Accelerator pedal released
    0.5 to 1.1 V
    Accelerator pedal depressed
    2.6 to 4.5 V

    Accelerator Pedal Position No. 2 Standard voltage:
    Condition
    Specified Condition
    Accelerator pedal released
    1.2 to 2.0 V
    Accelerator pedal depressed
    3.4 to 5.0 V

    HINT:
    If the results are not as specified, check the accelerator pedal, wire harness and ECM.