KNOCK SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap sub-assembly.
Loosen the cylinder block drain cock plug, then drain the coolant.

| 3. REMOVE CYLINDER HEAD COVER NO. 2 |
![]() |
Remove the 4 nuts and cylinder head cover No. 2.
| 4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE NO. 1 |
![]() |
Disconnect fuel vapor feed hose No. 1 and fuel vapor feed hose No. 2 from the vacuum switching valve assembly.
Disconnect the vacuum switching valve assembly connector and wire harness clamp.
![]() |
Disconnect ventilation hose No. 2.
![]() |
Disconnect the wire harness clamp and mass air flow meter connector.
![]() |
Loosen the hose clamp, unlock the air cleaner assembly clamp and remove air cleaner cap sub-assembly with air cleaner hose No. 1.
| 5. DISCONNECT WATER BY-PASS HOSE |
![]() |
Disconnect the water by-pass hose.
| 6. DISCONNECT WATER BY-PASS HOSE NO. 2 |
![]() |
Disconnect water by-pass hose No. 2.
| 7. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY |
![]() |
Disconnect the throttle with motor body assembly connector.
Remove the nut and remove the wire harness with bracket.
![]() |
Remove the 2 nuts and remove the water filler sub-assembly with hose.
![]() |
Remove the bolt and 3 nuts and remove the throttle with motor body assembly.
![]() |
Remove the gasket from the intake manifold.
| 8. REMOVE INTAKE MANIFOLD |
![]() |
Separate the engine wire harness from the intake manifold.
![]() |
Separate water by-pass hose No. 2.
![]() |
Disconnect the ventilation hose.
![]() |
Disconnect the union to connector tube hose.
![]() |
Remove the 3 bolts and 2 nuts and remove the intake manifold.
Remove the gasket from the intake manifold.
| 9. REMOVE KNOCK SENSOR |
![]() |
Disconnect the knock sensor connector.
Remove the nut and remove the knock sensor.