Home › ENGINE · 1NZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY


A093602E02
  1. Check the resistance.

    1. Measure the resistance between the terminals.

      Standard resistance:
      6.9 to 7.9 Ω at 20 °C (68°F)

      If the result is not as specified, replace the oil control valve assembly.



    A099422E01
  1. Check the operation.

    1. Connect the positive (+) battery lead to terminal 1 and the negative (-) lead to terminal 2, and check the movement of the valve.

      Standard:
      Condition
      Specified Condition
      Battery positive (+) voltage applied
      Valve moves in left arrow direction shown in the illustration
      Battery positive (+) voltage cut off
      Valve moves in right arrow direction shown in the illustration

      If the result is not as specified, replace the oil control valve.

      NOTICE:
      If the valve cannot return properly because of foreign matter intrusion, a small amount of leakage in the advanced direction may occur and a DTC may be output.