Home › ENGINE ยท 2NZ-FE › EMISSION CONTROL › CANISTER

CANISTER > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CANISTER


A119220
  1. Separate the purge hose.



    A125131
  1. Separate canister outlet hose sub-assembly No. 1.



    A106962E02
  1. Inspect the ventilation of the canister.

    1. Open the fuel tank cap, apply compressed air into the purge hose and check that the air flows out from canister outlet hose sub-assembly No. 1.



    2. A119187E01
    3. Open the fuel tank cap, apply compressed air into canister outlet hose sub-assembly No. 1 and check that the air flows out from the purge hose.



    A119132E01
  1. Inspect the check valve.



      A106963E02
    1. Open the fuel tank cap, close canister outlet hose sub-assembly No. 1 (C) and apply compressed air into the purge hose (B).

      Standard:
      Air does not flow at first. By gradually increasing the pressure, air flows when the pressure in the port reaches the specified level.



    2. A106961E02
    3. Open the fuel tank cap and close canister outlet hose sub-assembly No. 1 (C). Using a hand-held vacuum pump, apply a vacuum to purge hose (B).

      Standard:
      The vacuum is maintained at first. By gradually increasing the vacuum, air flows and the vacuum decreases after the vacuum reaches the specified level.