Home › ENGINE ยท 1NZ-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CAMSHAFT POSITION SENSOR


A104511
  1. Apply a light coat of engine oil to the O-ring on the camshaft position sensor.

  1. Install the camshaft position sensor with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    NOTICE:
    Do not twist the O-ring.

  1. Connect the camshaft position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. CHECK FOR ENGINE OIL LEAKAGE