Home › ENGINE ยท 2NZ-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


A091817
  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.

  1. Install the crankshaft position sensor with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

    NOTICE:
    Do not twist the O-ring.

  1. Connect the crankshaft position sensor connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. CHECK FOR ENGINE OIL LEAKAGE


4. INSTALL ENGINE UNDER COVER RH


5. INSTALL ENGINE UNDER COVER SUB-ASSEMBLY (for Rough Road Area Specification Vehicles)