Home › ENGINE ยท 2NZ-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY (for Rough Road Area Specification Vehicles)


4. REMOVE CRANKSHAFT POSITION SENSOR


A091817
  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt and remove the crankshaft position sensor.