CAMSHAFT > INSPECTION |
| 1. INSPECT CAMSHAFT TIMING GEAR ASSEMBLY |
Check the lock of camshaft timing gear.
Clamp the camshaft in a vice, and check that the camshaft timing gear is locked.
![]() |
Release the lock pin.
Cover the 4 oil paths of the cam journal with tape as shown in the illustration.
Puncture the tape covering the advance oil path and the retard oil path on the opposite side from the advance oil path.
![]() |
Apply air at about 150 kPa (1.5kgf*cm2) pressure into the 2 broken paths (the advance side path and the retard side path).
![]() |
Confirm that the camshaft timing gear assembly revolves in the timing advance direction when the air pressure on the timing retard path is reduced.
When the camshaft timing gear reaches the most advanced position, release the air pressure on the timing retard side path, and then release the air pressure on the timing advance side path.
Check the revolution.
Rotate the valve timing assembly back and forth several times, except where the lock pin meets it at the most retarded angle. Check the movable range and that it rotates smoothly.
Check the lock in the most retarded position.
Confirm that the camshaft timing gear assembly is locked in the most retarded position.