Home › ENGINE ยท 2NZ-FE › LUBRICATION › LUBRICATION SYSTEM

LUBRICATION SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ENGINE OIL LEVEL
  1. Warm up the engine, then stop the engine and wait for 5 minutes. Check that the engine oil level is between the low and full marks on the oil level gauge.
    If the engine oil level is low, check for oil leakage and add engine oil up to the full level mark.

    NOTICE:
    Do not add engine oil to above the full level mark.



2. CHECK ENGINE OIL QUALITY


A113813E01
  1. Check the oil for deterioration, water intrusion, discoloration or thinning.

    Oil grade:
    20W-50 and 15W-40:
    API grade SL or SM multigrade engine oil
    10W-30 and 5W-30:
    API grade SL Energy-Conserving, SM Energy-Conserving or ILSAC multigrade engine oil



3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
  1. Remove the engine under cover LH (w/o Rough Road Area Spec).

  1. Remove the engine under cover RH (w/o Rough Road Area Spec).

  1. Remove the engine under cover sub-assembly (w/ Rough Road Area Spec).

  1. Disconnect the engine oil pressure switch assembly connector.



    A104877
  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.



4. INSTALL OIL PRESSURE GAUGE


A104878
  1. Install the oil pressure gauge.



5. CHECK OIL PRESSURE
  1. Warm up the engine.

  1. Check the oil pressure.

    Standard oil pressure:
    Engine rpm
    Oil Pressure
    When idling
    29 kPa (0.3 kgf/cm2, 4.3 psi) or more
    At 3,000 rpm
    150 to 550 kPa (1.5 to 5.6 kgf/cm2, 22 to 80 psi) or more



6. REMOVE OIL PRESSURE GAUGE
  1. Remove the oil pressure gauge.



7. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


A050082E04
  1. Apply adhesive to the 2 or 3 end threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three bond 1324 or equivalent

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation.

  1. Connect the oil pressure switch assembly connector.

  1. Install the engine under cover RH (w/o Rough Road Area Spec).

  1. Install the engine under cover LH (w/o Rough Road Area Spec).

  1. Install the engine under cover sub-assembly (w/ Rough Road Area Spec).



8. CHECK FOR ENGINE OIL LEAKAGE