Home › ENGINE ยท 2NZ-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > DISASSEMBLY

for Preparation Click here



1. REMOVE WITH HEAD TAPER SCREW PLUG NO. 1


A062890E01
  1. Using a 10 mm socket hexagon wrench, remove the taper screw plug and the gasket.



2. REMOVE VALVE LIFTER

HINT:
Keep the valve lifters in the correct order so that they can be returned to their original locations when reassembled.



3. REMOVE WITH HEAD TAPER SCREW PLUG NO. 2


A038128E01
  1. Using an 8 mm hexagon wrench, remove the taper screw plug and gasket.



4. REMOVE OIL CONTROL VALVE FILTER (for Unleaded Gasoline Specification Vehicle)


5. REMOVE INTAKE VALVE


A037109E03
  1. Using SST, compress the valve spring and remove the 2 retainer locks, retainer and valve spring.

    SST
    09202-70020   (09202-00010)

    HINT:
    Keep the valves, valve springs, spring seats and spring retainers in the correct order so that they can be returned to their original locations when reassembled.



6. REMOVE EXHAUST VALVE
  1. Using SST, compress the valve spring and remove the 2 retainer locks, retainer and valve spring.

    SST
    09202-70020   (09202-00010)

    HINT:
    Keep the valves, valve springs, spring seats and spring retainers in the correct order so that they can be returned to their original locations when reassembled.



7. REMOVE VALVE STEM OIL SEAL


A080961E01
  1. Using needle-nose pliers, remove the oil seal.



8. REMOVE VALVE SPRING SEAT


A080962E01
  1. Using compressed air and a magnetic finger, remove the valve spring seats.



9. REMOVE STUD BOLT
  1. Using "Torx" socket wrenches E5 and E7, remove the 7 stud bolts.



10. REMOVE CAMSHAFT BEARING CAP SETTING RING PIN