CYLINDER HEAD > REASSEMBLY |
| 1. INSTALL CAMSHAFT BEARING CAP SETTING RING PIN |
![]() |
Using a plastic-faced hammer, tap a new ring pin in to the specified protrusion height.
| 2. INSTALL STUD BOLT |
Using "Torx" socket wrenches E5 and E7, install the 7 stud bolts.

| 3. INSTALL VALVE STEM OIL SEAL |
![]() |
Apply a light coat of engine oil to the valve stem.
![]() |
Using SST, push in a new oil seal.
| 4. INSTALL INTAKE VALVE |
![]() |
Install the valve, spring seat, valve spring, and spring retainer.
![]() |
Using SST, compress the valve spring and place the 2 retainer locks around the valve stem.
![]() |
Using a plastic-faced hammer and the valve stem (not in use) with its tip wrapped in tape, gently tap the valve stem tip to ensure a proper fit.
| 5. INSTALL EXHAUST VALVE |
Install the valve, spring seat, valve spring, and spring retainer.
Using SST, compress the valve spring and place the 2 retainer locks around the valve stem.
Using a plastic-faced hammer and the valve stem (not in use) with the tip wrapped in tape, lightly tap the valve stem tip to ensure a proper fit.
| 6. INSTALL OIL CONTROL VALVE FILTER |
Install the oil control valve filter.
| 7. INSTALL WITH HEAD TAPER SCREW PLUG NO. 2 |
![]() |
Using an 8 mm hexagon wrench, install the taper screw plug and a new gasket.
| 8. INSTALL VALVE LIFTER |
Apply a light coat of engine oil to the valve lifter.
Install the valve lifter.
Check that the valve lifter rotates smoothly by hand.
| 9. INSTALL WITH HEAD TAPER SCREW PLUG NO. 1 |
![]() |
Using a 10 mm socket hexagon wrench, install the taper screw plug with a new gasket.