Home › BODY ELECTRICAL › LIGHTING › REAR COMBINATION LIGHT ASSEMBLY (for Sedan)

REAR COMBINATION LIGHT ASSEMBLY (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL BACK UP LIGHT BULB


    E127144
  1. Install the back up light bulb into the socket.

  1. Turn the back up light socket, in the directions indicated by the arrow in the illustration, to install them.



2. INSTALL TURN SIGNAL LIGHT BULB


    E127143
  1. Install the turn signal light bulb into the socket.

  1. Turn the turn signal light socket, in the directions indicated by the arrow in the illustration, to install them.



3. INSTALL TAIL LIGHT AND STOP LIGHT BULB


    E127142
  1. Install the tail light and stop light bulb into the socket.

  1. Turn the tail light and stop light bulb socket, in the directions indicated by the arrow in the illustration, to install them.



4. INSTALL REAR COMBINATION LIGHT BODY GASKET


    E125483
  1. Install a new rear combination light body gasket.



5. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    E127141
  1. Install the rear combination light assembly onto the vehicle.



    E127140
  1. Connect the connector.

  1. Install the 2 nuts.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



6. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER


    E127139
  1. Engage the 5 clips and install the luggage compartment trim inner cover.



7. INSTALL REAR FLOOR FINISH PLATE


    E127138
  1. Engage the 2 clips and install the rear floor finish plate.



8. INSTALL DECK FLOOR BOX LH


    E129683
  1. Install the deck floor box and the deck side box door.



9. INSTALL DECK FLOOR BOX RH

HINT:
Use the same procedure as for the LH side.



10. INSTALL SPARE WHEEL COVER ASSEMBLY


    E129682
  1. Install the spare wheel cover assembly.



11. INSTALL LUGGAGE COMPARTMENT FLOOR MAT


    E129681
  1. Install the luggage compartment floor mat.



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }