REAR COMBINATION LIGHT ASSEMBLY (for Hatchback) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE REAR COMBINATION LIGHT COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, disengage the 6 claws and remove the rear combination light cover.
| 3. REMOVE REAR COMBINATION LIGHT ASSEMBLY |
![]() |
Remove the 2 nuts.
Disconnect the connector.
![]() |
Slide the tail light (rear combination light) toward the rear of the vehicle.
| 4. REMOVE REAR COMBINATION LIGHT BODY GASKET |
![]() |
Remove the rear combination light body gasket.
| 5. REMOVE REAR COMBINATION LIGHT BULB |
![]() |
Disengage the fitting of the rib.
Disengage the claw on the upper side, then on the lower side.
![]() |
Turn the 2 rear combination light bulbs (turn signal light bulb and back up light bulb), in the direction indicated by the arrows in the illustration, to remove them.
![]() |
Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to remove it.
![]() |
Remove the rear combination light bulb (tail light bulb) from the socket and wire.
![]() |
Turn the rear combination light socket and wire, in the direction indicated by the arrow in the illustration, to remove it.
![]() |
Remove the rear combination light bulb (stop light bulb) from the socket and wire.
| 6. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY |
![]() |
Disconnect the connector and remove the rear combination light socket and wire.