Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > REMOVAL

for Preparation Click here


CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


2. POSITION FRONT WHEELS FACING STRAIGHT AHEAD


3. REMOVE STEERING PAD (w/ Steering Pad Switch)


C117211E01
  1. Using "TORX" socket wrench T30, loosen the 2 bolts completely.

  1. Pull the steering pad toward you.



    C117199E01
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.



4. REMOVE STEERING PAD (w/o Steering Pad Switch)


C117209E01
  1. Using "TORX" socket wrench T30, loosen the 2 bolts completely.

  1. Pull the steering pad toward you.



    C117201E01
  1. Using a thin-bladed screwdriver, release the locking button.

  1. Using a thin-bladed screwdriver, detach the airbag connector.

  1. Detach the horn terminal.



5. REMOVE STEERING WHEEL ASSEMBLY


    C117210E02
  1. Remove the nut and place matchmarks on the steering wheel assembly and steering column assembly.
    Text in Illustration 
    *a
    Matchmark



    C117207E01
  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of the SST center bolt before using.



6. REMOVE STEERING COLUMN COVER


    C117204E01
  1. Remove the 3 screws, disengage the 2 claws, release the tilt lever and remove the steering column lower cover.



    C117205E01
  1. Disengage the claw and remove the steering column upper cover.



7. REMOVE SPIRAL CABLE (w/o Steering Sensor)


B108276E02
Text in Illustration 
*1
Slider
  1. Detach the horn connector.

  1. Slide the slider and detach the airbag connector.



    C118549
  1. Disengage the 3 claws and remove the spiral cable.



8. REMOVE WIPER SWITCH


E113830E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the wiper switch.

    NOTICE:
    Do not press the claw too hard, as it may be damaged.



9. REMOVE HEADLIGHT DIMMER SWITCH


E113831
  1. Disconnect the connector.

  1. Remove the headlight dimmer switch, as shown in the illustration.



    E113832
  1. Disengage the 2 claws and remove the headlight dimmer switch.