HAZARD WARNING SWITCH (for Sedan) > INSTALLATION |
| 1. INSTALL HAZARD WARNING SIGNAL SWITCH |
![]() |
Engage the 3 claws and install the hazard warning signal switch.
| 2. INSTALL INSTRUMENT PANEL CENTER REGISTER |
![]() |
Engage the 8 claws and install the instrument panel center register.
| 3. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY |
![]() |
Engage the 2 claws and 4 clips and install the instrument cluster finish panel center.
| 4. INSTALL INSTRUMENT PANEL FINISH PANEL END LH |
![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.
| 5. INSTALL INSTRUMENT PANEL FINISH PANEL END RH |
![]() |
Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.
| 6. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER |
![]() |
Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.
| 7. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1 |
![]() |
Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.
![]() |
Engage the 5 claws and 5 clips and install the instrument cluster finish panel.
| 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |