Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT LEVELING SWITCH (for Sedan)

HEADLIGHT LEVELING SWITCH (for Sedan) > INSPECTION

for Preparation Click here



1. INSPECT HEADLIGHT LEVELING SWITCH


E114455E06
  1. Check the ratio.

    1. Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 4.

    2. Check the ratio which is obtained by dividing the voltage between terminals 2 and 4 (V1) by the voltage between 1 and 4 (V2). The voltages must be measured using a voltmeter.

      HINT:
      The switch position can be adjusted in step of 0.5.

      Standard Ratio:
      Tester Connection
      Switch Position
      Specified Condition
      1 - 4 and 2 - 4
      0
      0.87 to 0.93
      0.5
      0.79 to 0.85
      1
      0.71 to 077
      1.5
      0.63 to 0.69
      2
      0.55 to 0.61
      2.5
      0.47 to 0.533
      3
      0.39 to 0.45
      3.5
      0.31 to 0.37
      4
      0.23 to 0.29
      4.5
      0.15 to 0.21
      5
      0.07 to 0.13

      If the result is not as specified, replace the headlight leveling switch.

  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 3 and the negative (-) battery lead to terminal 4, then check that the illumination illuminates.

      Standard:
      Illumination illuminates.

      If the illumination does not illuminate, replace the headlight leveling switch.