Home › BODY ELECTRICAL › WIPER AND WASHER › REAR WIPER MOTOR (for Hatchback)

REAR WIPER MOTOR (for Hatchback) > INSTALLATION

for Preparation Click here



1. INSTALL REAR WIPER MOTOR


B210526
  1. Install the rear wiper motor with the 3 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connector.



2. INSTALL REAR WIPER MOTOR GROMMET


E107901
  1. Install the rear wiper motor grommet.



3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


E058837E10
  1. Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).

  1. Clean the wiper pivot serrations with a wire brush.

  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.



    E107904E01
  1. Install the rear wiper arm into the position shown in the illustration with the nut.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    HINT:
    Hold the arm hinge down by hand while tightening the nut.



    E107903
  1. Close the rear wiper arm head cap.



4. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


B118076
  1. Engage the 3 claws and 9 clips and install the back door trim board.



    B104995
  1. Slide the handle plate of the back door trim board to engage it.